Altium Designer 기술문서
...
((Dialog Reference))_AD
Dialogs((S to Z))_AD
PCB_Dlg-ChangeTrackTrack_AD
The Track Dialog.
Summary
The Track dialog allows the designer to modify the properties of a track object. Note that a line is also a track object, the term line is used to indicate that the object is intended to be a non-net object, so it will not automatically inherit the net name of a touching object. A line also presents a different dialog if Tab is pressed during placement.
Access
The Track dialog can be accessed prior to entering placement mode, from the PCB Editor – Defaults page of the Preferences dialog. This allows the default properties for the track object to be changed, which will be applied when placing subsequent tracks.
During placement, the dialog can be accessed by pressing the Tab key.
After placement, the dialog can be accessed in the following ways:
- Double-clicking on a track object.
- Placing the cursor over a track, right-clicking and selecting the Properties command from the context menu.
- Using the Edit » Change command and clicking once over a placed track object.
Options/Controls
- Start X/Y - Shows the current X/Y coordinate of the track start point, relative to the current origin.
- End X/Y - Shows the current X/Y coordinate of the track end point, relative to the current origin.
- Width - Shows the current width of the track. Edit this field to change the track width, within the range 0.001mil to 10000mil.
Properties
- Layer - Define which layer the track is on.
- Net - Select the Net that this track is to belong to. Note that if track placement commences at the same location as an existing object that is already connected to a Net, then the Net property of the new object is automatically assigned to that Net.
- Locked - Lock the object so that it cannot be edited graphically.
- Keepout - Check this box to set the object to act as a layer-specific Keepout object. A Keepout object is displayed in the layer color, outlined in the Keepout color. A keepout object is used on a signal layer to create a layer-specific keepout. Layer-specific keepouts are not included during output generation.
- Solder Mask Expansion - this field allows you to enable and control the expansion to be used with respect to the track on the Solder Mask layer, to create the required opening in the mask. This opening can be larger (a positive expansion value) or smaller (a negative expansion value) than the track itself. The following options are available:
- No Mask - no opening in the solder mask.
- Expansion value from rules - choose this option to have the solder mask expansion for the track follow the defined value in the applicable Solder Mask Expansion design rule.
- Specify expansion value - choose this option to override the applicable design rule and specify the solder mask expansion value for the track.
- Paste Mask Expansion - this field allows you to enable and control the expansion to be used with respect to the track on the Paste Mask layer, to create the required opening in the mask. This opening can be larger (a positive expansion value) or smaller (a negative expansion value) than the track itself. The following options are available:
- No Mask - no opening in the paste mask.
- Expansion value from rules - choose this option to have the paste mask expansion for the track follow the defined value in the applicable Paste Mask Expansion design rule.
- Specify expansion value - choose this option to override the applicable design rule and specify the paste mask expansion value for the track.