Parent page: PCB Commands
The following pre-packaged resources, derived from this base command, are available:
Place Embedded Board Array
Applied Parameters: None
Summary
This command is used to place an Embedded Board Array object onto the active document. An Embbeded Board Array allows you to create a PCB panel (representing the physical board that the PCB is to be manufactured from) as part of your PCB design project. This is also known as panelization . You can use this panel to hold an array of PCBs. This command links the panel to the original PCB design files, stepping it out the specified number of times. You cannot edit the PCBs directly from the board array, only through their original files.
Multiple embedded board arrays can be placed and each can reference a different PCB file. By spacing out the boards in each array and then overlaying, rotating and flipping the different embedded arrays, any panelization arrangement can be created. This can be used to reduce manufacturing costs by maximizing the number of PCBs per panel of PCB material.
Access
This command is accessed from the PCB Editor by choosing the Place » Embedded Board Array/Panelize command, from the main menus.
Use
After launching the command, the Embedded Board Array dialog will appear. Use this dialog to choose the reference PCB document, and configure the array as required. After clicking OK, the cursor will change to a cross-hair and you will enter embedded board array placement mode. Placement is made as follows:
- The location of the cross-hair decides the lower-left corner of the board array. Position this corner of the array at the required location and click, or press Enter, to place the array.
- The Embedded Board Array dialog reappears. Configure another array to place, with the same or different reference PCB, or click Cancel, or press Esc, to exit placement mode.
Additional actions that can be performed during placement are:
- Press the Spacebar to rotate the array anti-clockwise. Rotation is anti-clockwise and in steps of 90°.
- Press the L key to flip the array to the other side of the board.
Tips
- If you are building a panel consisting of different PCB boards, it is important that you ensure the layer stackup for each board is compatible.
- If a placed array does not yet reference a PCB document, there'll only be a small cross presented in the workspace, to mark the lower-left corner of the array boundary. This cross appears in the color of the layer on which the array resides.
- Control the display of embedded board array objects in the workspace, using the Show Embedded Board Arrays option, on the Show/Hide tab of the View Configurations dialog.
- While attributes can be modified during placement (in the associated properties dialog), bear in mind that these will become the default settings for further placement unless the Permanent option on the PCB Editor – Defaults page of the Preferences dialog is enabled. When this option is enabled, changes made will affect only the object being placed and subsequent objects placed during the same placement session.