SystemDesigner_Cmd-ViewFitViewFit_AD

Created: 七月 07, 2017 | Updated: 三月 06, 2024 | Applies to versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: SystemDesigner Commands

The following pre-packaged resource, derived from this base command, is available:

Fit Document

Applied Parameters: None

Summary

This command is used to change the view in the main design window, such that the active Multi-board Schematic document (*.MbsDoc) is made completely visible (where possible).

For a high-level look at multi-board design within Altium NEXUS, see Designing Systems with Multiple Boards.

Access

This command can be accessed from the Multi-board Schematic Editor by:

Choosing the View » Fit Document command, from the main menus.
Using the Ctrl+PgDn keyboard shortcut.

Use

After launching the command, the view in the main design window will change in order to fit the entire document, where possible. This of course will depend on the current sizing of the main design workspace within Altium NEXUS, but the software will attempt to fit what it can, with the center of the document at the center of the main design window.

适合打印版本

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

SystemDesigner_Cmd-ViewFitViewFit_AD

Summary

Access

Use

Was this page helpful?