Applied Parameters: None
Summary
This command is used to run the PDN Analyzer with which you can analyze a board design's DC performance based on its electrical and physical properties.
Access
This command can be accessed from the Schematic Editor by:
- Clicking Tools » PDN Analyzer from the main menus.
The dialog can only be accessed if the
IPC Footprint Generator extension is installed as part of your Altium NEXUS installation. This extension is installed by default, but if it is inadvertently uninstalled, the extension can be found on the
Purchased tab of the
Extensions & Updates page, located by clicking the
drop-down then choosing
Extensions and Updates. Hover over the icon then click
to download the extension. Altium NEXUS must be restarted to complete installation.
Use
After launching the command, the PDN Analyzer will open.
Tips
- The PDN Analyzer extension must be installed before the PDN Analyzer can be accessed.
Altium NEXUS 文档
...
命令参考
PDNAnalyzer Commands