PatternsGen_Cmd-GeneratePatternsGeneratePatterns_AD

Applied Parameters: None

Summary

This command is used to open the Dielectric Shapes Generator dialog to automatically create dielectric shapes.

Access

This command is accessed from the PCB editor by choosing Tools » Printed Electronics » Generate Dielectric Patterns from the main menus.

Use

After launching the command, the Dielectric Shapes Generator dialog opens. Use the dialog to create the dielectric shapes needed for Printed Electronics.

Tip

• When the Dielectric Shapes Generator is run, it will remove all shapes on the target layer(s), then recreate them. If shapes have been defined manually, lock them before running the Dielectric Shapes Generator.