PatternsGen_Cmd-GeneratePatternsGeneratePatterns_AD

Applied Parameters: None

Summary

This command is used to open the Dielectric Shapes Generator dialog to automatically create dielectric shapes. 

Access

This command is accessed from the PCB editor by choosing Tools » Printed Electronics » Generate Dielectric Patterns from the main menus.

The Patterns Generator extension must be installed in order to access this command. The extension icon can be found on the Purchased tab of the Extensions & Updates page, which is located by clicking the  drop-down then choosing Extensions and Updates. 
 

Hover over the icon then click  to download the extension. Altium Designer must be restarted to complete the installation. 

After launching the command, the Dielectric Shapes Generator dialog opens. Use the dialog to create the dielectric shapes needed for Printed Electronics.

Tips

1. When the Dielectric Shapes Generator is run, it will remove all shapes on the target layer(s), then recreate them. If shapes have been defined manually, lock them before running the Dielectric Shapes Generator.