Dialog-Edit Aperture
Created: 9月 27, 2017 | Updated: 7月 01, 2024
| Applies to versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1 and 3.2
現在、バージョン 2.0. をご覧頂いています。最新情報については、バージョン Dialog-((Edit Aperture)) の 5 をご覧ください。
The Aperture dialog
Summary
The Aperture dialog provides controls to set up the required aperture information for the design.
Access
The dialog is accessed by performing the following steps:
- In the Apertures tab of the Gerber Setup dialog, disable the Embedded apertures (RS274X) option.
- Click the New button under the Apertures List region.
- Click OK in the resulting DCode dialog.
Options/Controls
- X Size - specify the X size for the aperture.
- Y Size - specify the Y size for the aperture.
- Corner Radius - specify the corner radius of the aperture. This option is only available when Rounded Rectangle is selected for Shape.
- Hole Size - specify the hole size for the aperture.
- Shape - use the drop-down to select the shape for aperture. Options include: Rounded, Rectangle, Octagonal, Rounded Rectangle, and Relief.
- Use For - use the drop-down to select the purpose of the aperture. Options include: Anything, Drawing and Flashing.
- Rotation - specify the rotation angle of the aperture.
- X Offset - specify the offset in X direction. This option is not available if Relief is selected for Shape.
- Y Offset - specify the offset in Y direction. This option is not available if Relief is selected for Shape.
- The following entries are avaliable only when Relief is selected for Shape:
- Relief Width - specify the width of the relief connection.
- Relief Gap - specify the width of each air gap in the relief connection.
- Hole Type - use the drop-down to select the hole type. Options include: Round, Square and Slot.
- Relief Entries - select 2 or 4 for the number of relief entries to be applied to the aperture.