CAMTASTIC_Cmd-ToolsMillViewOriginalToolsMillViewOriginal_AD

Applied Parameters: CommandMode=NC

Summary

This command is used to toggle the display of the original centerline of the rout path - the path with no cutter compensation offset applied.

Access

This command is accessed from the CAMtastic Editor by choosing the View » Display Symbols » Centerline Path command from the main menus.

Use

After launching the command, the display of the original centerline path for rout paths in the design will be toggled ON or OFF, depending on the current status. The centerline path is a solid line and shows the rout path that is taken if no cutter compensation offset is applied.

Tips

1. The effect of this command is noticeable only when the Fill mode is turned OFF.