Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Paste Array
Applied Parameters: None
Summary
This command is used to place the current clipboard contents onto the current document, as a vertical or horizontal object array.
Access
This command is accessed from the Schematic Library Editor by choosing the Edit » Paste Array command, from the main menus.
Use
After launching the command, the Setup Paste Array dialog will appear. Set up the various options as required and click OK.
You will be prompted to select a start location on the document, where the array will be inserted. Simply position the cursor at the desired location and click or press Enter. The array will be pasted at the chosen start location.
Tips
- Enter positive or negative values for spacing, to determine whether the array will be pasted to the right or left respectively for horizontal placement, or upwards or downwards respectively for vertical placement.
Altium Designer Documentation
...
((Command Reference))_AD
((Sch Commands))_AD