Parent page: Schematic Commands
The following pre-packaged resources, derived from this base command, are available:
Jump to Origin
Applied Parameters: Origin=TRUE
Summary
This command is used to move the cursor to the absolute origin coordinate (0,0) for the current document. The abosulte origin point corresponds to the bottom-left corner of the schematic sheet.
Access
This command can be accessed from the Schematic Editor, and Schematic Library Editor, by:
- Choosing the Edit » Jump » Origin command from the main menus.
- Using the Ctrl+Home keyboard shortcut.
- Within the main design workspace, pressing the J key, then choosing Origin from the subsequent pop-up menu (or using the J, O keyboard sequence).
Use
After launching the command, the cursor will jump to the absolute origin for the document (coordinate 0,0). The coordinate will be zoomed and centered (where possible) in the main design window.