PCB_Cmd-RotateSelectedObjectsRotateSelectedObjects_AD

Created: сентября 26, 2017 | Updated: марта 06, 2024 | Applies to versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5

Вы просматриваете версию 1.1. Для самой новой информации, перейдите на страницу PCB_Cmd-RotateSelectedObjects((RotateSelectedObjects))_AD для версии 5

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:

Rotate Selection

Applied Parameters: None

Summary

This command is used to rotate selected objects in the workspace counterclockwise or clockwise and by a specified angle of rotation.

Access

This command can be accessed from the PCB Editor and PCB Library Editor when configured in 2D Layout Mode by:

Choosing the Edit » Move » Rotate Selection command from the main menus.

The current viewing mode for the PCB document (or PCB Library document) can be changed using the corresponding commands from the main View menu. To switch to 2D Layout Mode, use the command of the same name or use the 2 keyboard shortcut.

Use

Ensure that only the objects you wish to rotate are selected in the main design workspace.

After launching the command, the Rotation Angle (Degrees) dialog will open. Enter the required angle of rotation from 0.001° to 360.00°. Enter a positive value for counterclockwise rotation or a negative value for clockwise rotation. Click OK to close the dialog then position the cursor and click to define the reference point for rotation. The selected objects will be rotated about the reference point by the entered angle.

Tips

The Undo command can be used to restore the rotated selection.

Rotate Selection (from Active Bar)

Applied Parameters: None

Summary

This command is used to rotate selected objects in the workspace counterclockwise or clockwise and by a specified angle of rotation.

Access

This command can be accessed from the PCB Editor and PCB Library Editor when configured in 2D Layout Mode by:

Locating and using the Rotate Selection command on the Active Bar.

Click and hold on the active button to access a menu of all associated commands for that grouping. If the command has been recently used from the Active Bar, it will become the active/visible button. When other commands are available it is indicated by a triangle at the bottom-right corner of the button.

Use

Ensure that only the objects you want to rotate are selected in the main design workspace.

After launching the command, the Rotation Angle (Degrees) dialog will open. Enter the required angle of rotation, from 0.001° to 360.00°. Enter a positive value for counterclockwise rotation or a negative value for clockwise rotation. Click OK to close the dialog then position the cursor and click to define the reference point for rotation. The selected objects will be rotated about the reference point by the entered angle.

Tips

The Undo command can be used to restore the rotated selection.

Версия для печати

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

PCB_Cmd-RotateSelectedObjectsRotateSelectedObjects_AD

Summary

Access

Use

Tips

Summary

Access

Use

Tips

Was this page helpful?