Конструирование с сенсорным управлением
How many of us got into electronics because we were drawn by the myriad of cool switches, knobs, lights and other suitably gadget-centric controls? Fast forward a good few years and that allure is still there, only it is now replaced with the "Snazzy GUI" factor - electronic products that have a sleek, sexy interface. Central to these ever-advancing (and shrinking) product interfaces is touch control. Subtle yet powerful, touch control makes a product more efficient to use, typically lowers the manufacturing cost and, by virtue of replacing mechanical switches and dials - that are at the mercy of inevitable wear and tear - increases the life-span of that product. Pick up your favorite piece of smart technology and you will soon realize that without touch control, it would simply be, well, not so smart - and certainly far less engaging and fun.
Altium Designer provides support for creating planar capacitive sensor patterns on your PCB. The following vendors are supported:
- Atmel Touch Controls - various self-capacitance and mutual-capacitance sensor patterns (buttons, wheels, sliders) are available, for use with Atmel® QTouch® and QMatrix® sensor controllers.
- Cypress Touch Controls - various self-capacitance sensor patterns (buttons, sliders) are available, for use with Cypress® CapSense® controllers.
- Microchip Touch Controls - various self-capacitance sensor patterns (ring, sliders) are available, for use with Microchip® mTouch® controllers.
Installing Touch Sensor Support
Touch Sensor support can be included as part of initial installation of Altium Designer. Simply ensure that the Touch Sensor Support option (for the required vendor(s)) is enabled, on the Select Design Functionality page of the Altium Designer Installer.
Add Touch Sensor support as part of initial installation of Altium Designer.
Installing touch sensor support for a particular vendor installs the relevant library of components needed for the different touch sensor technologies supported for that vendor, including touch wheels, sliders, and buttons. All components are configurable, allowing you to specify the size and orientations of the touch sensor geometries, in accordance with your design requirements.
Transferring the design to the PCB domain generates the geometries for the touch sensors. Then it's just a case of placing the sensors on the board at the locations they are required to facilitate your product's user interface, then wiring them up to the applicable touch sensor controllers.