LayerStackManager_Cmd-EnableFeatureEnableFeature_AD

Created: December 04, 2018 | Updated: March 06, 2024 | Applies to versions: 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5

Now reading version 3.0. For the latest, read: LayerStackManager_Cmd-EnableFeature((EnableFeature))_AD for version 5

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Enable Feature

Applied Parameters: Index=n (where n is in the range 0-15)

Summary

This feature is used to choose the desired feature (Printed Electronics, Rigid/Flex, and Back Drills).

Access

This command can be accessed from the Layer Stack Manager in the following ways:

Choose Tools » Features from the main menus then select the desired feature. Choices are Printed Electronics, Rigid/Flex, and Back Drills.
Use the Features drop-down in the upper-right of the Layer Stack Manager then select the desired feature. Choices are Printed Electronics, Rigid/Flex, and Back Drills.

Use

After launching the command, the chosen feature will be enabled. When Printed Electronics is selected, all dielectric layers are removed from the layer stack currently displayed in the Layer Stack Manager. When Rigid/Flex is selected, substack name buttons appear at the top of the Layer Stack Manager. When Back Drills is selected, the Back Drills tab is used to define the layer-spans that are required to be back drilled, when there is a pad or via stub present.

프린터 출력용 버전

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

LayerStackManager_Cmd-EnableFeatureEnableFeature_AD

Summary

Access

Was this page helpful?