Client_Cmd-ViewToolsMenuViewToolsMenu_AD

Created: July 25, 2017 | Updated: March 06, 2024 | Applies to versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2 and 4

Now reading version 2.1. For the latest, read: Client_Cmd-ViewToolsMenu((ViewToolsMenu))_AD for version 5

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Client Commands

The following pre-packaged resources, derived from this base command, are available:

Toggle Toolbar Display

Applied Parameters: ObjectKind=Toolbar | Index=n (where n is in the range 1 to 16)

Summary

This command is used to toggle the indicated toolbar on (displayed) or off (not displayed).

Access

The related indexed commands are accessed from most editors, from the View » Toolbars sub-menu.

Use

After launching the command, the indicated toolbar will either disappear or reappear, depending on whether it is currently visible or not.

Tips

The specific toolbar targeted by this command will depend on the current Editor being used.
A toolbar is fully dockable, or can float within, or outside of, the Altium NEXUS environment.
When a toolbar is placed over an editor, it can be set to fade when the cursor is passed over it, whilst in an editing mode such as movement or placement. The extent of fading (transparency) is defined on the System - Transparency page of the Preferences dialog.
When moving a toolbar, to prevent it from automatically docking use the Ctrl key.

Toggle Panel Display

Applied Parameters: ObjectKind=Panel | Index=m | Category=n | Action=Toggle (where m is in the range 1 to 40, and n is in the range 1 to 10)

Summary

This command is used to toggle the indicated panel on (displayed) or off (not displayed).

Access

The related indexed commands are accessed from most editors, from the View » Panels sub-menu.

Use

After launching the command, the indicated panel will either disappear or reappear, depending on whether it is currently visible or not.

Tips

The specific panel targeted by this command will depend on the current Editor being used.
A panel is fully dockable, or can float within, or outside of, the Altium NEXUS environment.
When a panel is placed over an editor, it can be set to fade when the cursor is passed over it, whilst in an editing mode such as movement or placement. The extent of fading (transparency) is defined on the System - Transparency page of the Preferences dialog.
When moving a panel, to prevent it from automatically docking use the Ctrl key.

프린터 출력용 버전

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

Client_Cmd-ViewToolsMenuViewToolsMenu_AD

Summary

Access

Use

Tips

Summary

Access

Use

Tips

Was this page helpful?