Working with the Component Orientations Design Rule on a PCB in Altium Designer
Created: February 22, 2016 | Updated: April 11, 2017
| Applies to versions: 16.0, 16.1, 17.0 and 17.1
Now reading version 16.1. For the latest, read: Working with the Component Orientations Design Rule on a PCB in Altium Designer for version 21
Rule category: Placement
Rule classification: Unary
Summary
This rule specifies allowable component orientations. Multiple orientations are permitted, allowing the Autoplacer to use any of the enabled orientations.
Constraints
Default constraints for the Component Orientations rule.
- Allowed Orientations– the chosen orientations that are made available for use by the Cluster Placer. The following orientation-based options are available:
- 0 Degrees – allows the Autoplacer to rotate a component to the 0° orientation.
- 90 Degrees – allows the Autoplacer to rotate a component to the 90° orientation.
- 180 Degrees – allows the Autoplacer to rotate a component to the 180° orientation.
- 270 Degrees – allows the Autoplacer to rotate a component to the 270° orientation.
- All Orientations – allows the Autoplacer to rotate a component to any of the four individual orientations.
How Duplicate Rule Contentions are Resolved
All rules are resolved by the priority setting. The system goes through the rules from highest to lowest priority and picks the first one whose scope expression matches the object(s) being checked.
Rule Application
During autoplacement with the Cluster Placer.