Altium Designer 기술문서
...
((Dialog Reference))_AD
Dialogs((S to Z))_AD
PCB_Dlg-RemoveUnusedPadsOptionsUnused Pad Shapes_AD
Created: July 28, 2015 | Updated: June 19, 2017
| Applies to versions: 15.1, 16.0, 16.1, 17.0 and 17.1
Now reading version 17.1. For the latest, read: PCB_Dlg-RemoveUnusedPadsOptions((Unused Pad Shapes))_AD for version 22
The Unused Pad Shapes dialog, used to configure to remove or restore unused pad shapes.
Summary
An unused pad shape is the pad shape in a pad or via that is not used on a layer (it has no other objects touching it on that layer). These unused pad shapes can consume valuable board area, particularly when there are polygons pours on those layers. If unused pad shapes are removed, then polygon clearances are to the pad or via hole, rather than the edge of the unused pad shape.
Access
In the PCB Editor, select Tools » Remove Unused Pad Shapes from the toolbar.
Options/Controls
- Scope
- Vias - examine all vias in the design and remove unused pad shapes.
- Pads - examine all pads in the design and remove unused pad shapes.
- Operation
- Remove unused - use the tool to remove unused pad shapes.
- Restore unused - use the tool to restore removed pad shapes to all vias.
- Selected only - examine only selected vias or pads and remove unused pad shapes.
- Preserve pads on start and end layers - a pad or via might not use the pad shape on the outer most layers that its structure exists on; these outer-layer pad shapes can be retained if required. Confirm that pad-less-outer-layer pads or vias are supported by your fabricator before disabling this option.
Tips
- To ensure that existing polygons recover all available copper area that was lost to unused pad shapes in pads and vias, run the Tools » Polygon Pours » Repour All Polygons command after removing unused pad shapes.