WorkspaceManager_Cmd-PlaceCommentPlaceComment_AD

Applied Parameters: EditorKind=CustomPaint_PlaceComment

Summary

This command is used to place a comment in a PCB, PCB library, schematic, or schematic library document that is saved in a Workspace.

Access

Click  near the top-right corner of the design space.

Use

After launching the command, the cursor changes to a crosshair with a blue circle at the center. Position the crosshair where you want the comment located on a PCB, PCB library, schematic, or schematic library document then click. The Comments panel opens in which you can enter then post your comment.