SimView_Cmd-RecallWaveformRecallWaveform_AD

Applied Parameters: None

Summary

This command is used to recall (or load) a waveform that has previously been stored.

Access

This command is accessed from the SimData Editor by choosing the Tools » Recall Waveform command from the main menus.

Use

After launching the command, a File Explorer dialog will open in which you can browse to and open the required waveform file (<StoredFileName>.wdf). The waveform will be recalled and loaded into the list of possible source simulation data waveforms for the active chart.

Notes

• The possible source simulation waveforms for the current chart are listed in the Source Data dialog (Chart » Source Data). From this dialog, you can create new waveforms to add to the list, edit existing waveforms, delete waveforms, and store and retrieve waveforms as required.
• If a waveform is recalled that possesses the same name as an existing waveform in the list, the recalled waveform will be given the suffix _1. Subsequent recall of the same waveform will result in waveforms appearing in the list with incremented suffixes (_2, _3, etc.).
• The list of possible source simulation waveforms that can be added to the active chart are also listed in the Source Data region of the Sim Data panel.