Parent page: LayerStackManager Commands
The following pre-packaged resource, derived from this base command, is available:
Add Layer
Applied Parameters: Index=n (where n is in the range 0-15)
Summary
This feature is used to add a layer to the active Layer Stack.
Access
This command can be accessed from the Layer Stack by:
- Choosing the Edit » Add Layer command from the main menus then selecting the desired layer type from the sub-menu.
Use
After launching the command, the selected layer will be added to the active Layer Stack.
Tips
- Adding a copper layer will also add a dielectric layer when an existing adjacent layer is also a copper layer.