Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: LocationMark=n (where n is in the range 1 to 10)
This command is used to store the coordinates of a position in the current document, as defined by the user, in the nth location marker. This position can be accessed quickly by using the corresponding Jump Location Mark n command.
This command is accessed from the Schematic Editor by choosing the Edit » Jump » Set Location Marks » n command, from the main menus.
After launching the command, the cursor will change to a crosshair. Simply position the cursor at the point in the workspace that you wish to create a marker and click. The coordinates of this position will be stored in the nth location marker.