PCB_Cmd-ConnectSubnetsConnectSubnets_AD

Created: сентября 06, 2016 | Updated: июля 13, 2018 | Applies to versions: 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

Вы просматриваете версию 18.0. Для самой новой информации, перейдите на страницу PCB_Cmd-ConnectSubnets((ConnectSubnets))_AD для версии 22

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:

Add Subnet Jumpers

Applied Parameters: None

Summary

This command is used to automatically add subnet connectors to complete the short routing segments (those tracks that still have connection lines in between) on the current PCB document - eliminating the need for the manual completion of such segments. An added subnet jumper completes the route between two tracks that have the same net property.

Access

This command is accessed from the PCB Editor by choosing the Route » Add Subnet Jumpers command from the main menus.

Use

After launching the command, the Subnet Connector dialog will open and you will be prompted to enter a value for the maximum subnet separation (100mil/2.54mm is the default value) of incomplete routing segments. After clicking OK, the software will detect any direct (horizontal, vertical or diagonal) connection lines shorter than the specified separation; track segments of the correct width will be automatically added to complete a route.

Tips

A group of tracks can be broken (using slicing, for example) to create short horizontal and vertical gaps. These gaps allow the subsections of nets to be re-assigned using the pin/net swapping system. Partially routed tracks with many tangled connection lines are typical in an FPGA design.

Remove Subnet Jumpers

Applied Parameters: Action=RemoveSubnetJumpers

Summary

This command is used to remove existing subnet connectors from the current PCB document.

Access

This command is accessed from the PCB Editor by choosing the Route » Remove Subnet Jumpers command from the main menus.

Use

After launching the command, the existing subnet jumpers (short connections between routed segments) are removed from the PCB.

Tips

Use the Add Subnet Jumpers command to create new jumpers for the PCB.

Версия для печати

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

Примечание

Набор доступных функций зависит от вашего уровня доступа к продуктам Altium. Ознакомьтесь с функциями, включенными в различные уровни Подписки на ПО Altium, и функциональными возможностями приложений, предоставляемых платформой Altium 365.

Если вы не видите в своем ПО функцию, описанную здесь, свяжитесь с отделом продаж Altium, чтобы узнать больше.

PCB_Cmd-ConnectSubnetsConnectSubnets_AD

Summary

Access

Use

Tips

Summary

Access

Use

Tips

Was this page helpful?