ActiveBOM_Dlg-PcbSourceSelectionDialogChoose PCB to Use_AD
Created: сентября 05, 2017 | Updated: января 26, 2019
| Applies to versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1 and 20.2
Вы просматриваете версию 20.1. Для самой новой информации, перейдите на страницу ActiveBOM_Dlg-PcbSourceSelectionDialog((Choose PCB to Use))_AD для версии 21
The Choose PCB to Use dialog
Summary
The Choose PCB to Use dialog is used to select which PCB parameters are to be made available in an ActiveBOM when a PCB project includes more than one PCB file.
Access
The dialog is accessed by clicking in the Sources region on the Columns tab of the ActiveBOM Properties panel.
Options/Controls
- PCB Files - this is a list of all PCB files detected in the current PCB project. Select the PCB to use then click OK. The following PCB-specific parameters will be extracted from that PCB and presented in the Columns list, ready to be included in ActiveBOM.
- Center-X (Mil) - geometric center of the component
- Center-Y (Mil)
- Center-X (mm)
- Center-Y (mm)
- Layer
- Pad-X (Mil) - location of Pad 1
- Pad-Y (Mil)
- Pad-X (mm)
- Pad-Y (mm)
- Ref-X (Mil) - location of component reference point (as defined in the PCB library editor)
- Ref-Y (Mil)
- Ref-X (mm)
- Ref-Y (mm)
- Rotation