PCB_Dlg-InputCoordDialog_CoordEditSnap Grid(1..1000) _AD

現在、バージョン 18. をご覧頂いています。最新情報については、バージョン PCB_Dlg-InputCoordDialog_CoordEdit((Snap Grid(1..1000) ))_AD の 22 をご覧ください。

The Snap Grid (1..1000) dialog
The Snap Grid (1..1000) dialog

Summary

The Snap Grid dialog allows you to quickly set a different interval size for the Snap Grid. The Snap Grid pulls the cursor to the nearest point on its defined grid. Depending on how the dialog is accessed, the required value can be applied to both Step X and Step Y, or only Step X, or only Step Y.

For more information about the PCB Grids System, click here.

Access

The dialog can be accessed from both the PCB Editor and PCB Library Editor in the following ways:

  • Click View » Grids » Set Global Snap Grid from the main menus.
  • Use the Shift+Ctrl+G keyboard shortcut.

Options/Controls

Enter the grid interval as required.

The entered grid size is reflected at the left-hand side of the status bar. If the grid was set globally (for both Step X and Step Y), then a single entry for the grid value will be displayed. If the grid was set for Step X or Step Y individually, the individual grid steps will be displayed. The current step sizes for the Snap Grid can also be verified in the Cartesian Grid Editor dialog.
If entering a snap grid setting without specifying units, the entry will be in the default measurement units selected for the design as determined by the Units setting in the Other region in the Board mode of the Properties panel. Specifying units when entering the value (mm or mil) in this dialog will change the default measurement units for the document if not currently the default.
If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.
注記

利用できる機能は、Altium 製品のアクセスレベルによって異なります。Altium Designer ソフトウェア サブスクリプション の様々なレベルに含まれる機能と、Altium 365 プラットフォーム で提供されるアプリケーションを通じて提供される機能を比較してください。

ソフトウェアの機能が見つからない場合は、Altium の営業担当者に連絡して 詳細を確認してください。