PCB_Cmd-SetComponentReferenceSetComponentReference_AD

Created: 7月 27, 2015 | Updated: 7月 17, 2018 | Applies to versions: 15.1, 16.0, 16.1, 17.0, 17.1, 18.0, 18.1, 19.0, 19.1, 20.0, 20.1, 20.2 and 21

現在、バージョン 18. をご覧頂いています。最新情報については、バージョン PCB_Cmd-SetComponentReference((SetComponentReference))_AD の 22 をご覧ください。

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:

Set Component Reference to Pin 1

Applied Parameters: Location=Pin1

Summary

This command is used to set the component reference point to be pin 1 of the component footprint.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Pin 1 command from the main menus.

Use

First, ensure that the component that you wish to set the reference for is selected in the Components list in the PCB Library panel (and is therefore the active component in the main design window).

After launching the command, the reference point will be set to pin 1 of the footprint and this point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked up by the cursor in Place and Move operations.

Set Component Reference to Center

Applied Parameters: Location=Center

Summary

This command is used to set the component reference point to be the center of the component footprint.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Center command from the main menus.

Use

After launching the command, the reference point will be set to the center of the footprint and this point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked-up by the cursor in Place and Move operations.

Set Component Reference to Location

Applied Parameters: None

Summary

This command is used to set the component reference point to a user-defined location.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Location command from the main menus.

Use

After launching the command, the cursor will change to a cross-hair and you will be prompted to select a new relative origin. Position the cursor at the point you wish to make the reference then click or press Enter. This point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked-up by the cursor in Place and Move operations.

印刷用ページ

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.

注記

利用できる機能は、Altium 製品のアクセスレベルによって異なります。Altium Designer ソフトウェアサブスクリプションの様々なレベルに含まれる機能と、Altium 365 プラットフォームで提供されるアプリケーションを通じて提供される機能を比較してください。

ソフトウェアの機能が見つからない場合は、Altium の営業担当者に連絡して詳細を確認してください。

PCB_Cmd-SetComponentReferenceSetComponentReference_AD

Summary

Access

Use

Tips

Summary

Access

Use

Tips

Summary

Access

Use

Tips

Was this page helpful?