Edit PCB Rule (from Schematic)

   A few variations of the Edit PCB Rule (From Schematic) dialog: Max-Min Width, Routing Layers, Solder-Mask Expansion, and Clearance Rules. 

Summary

The Edit PCB Rule (From Schematic) dialog allows you to define the constraints for a PCB rule from a schematic document.

Access

The dialog is accessed by completing the following steps:

1. In a schematic, click on a placed Parameter Set Directive (or click Place » Directives » Parameter Set then press Tab) to open the Properties panel in Parameter Set mode. 
2. Double-click the desired rule in the Rules region of the panel (or click the Add button and add a rule in the resulting Choose Design Rule Type dialog). 

Options/Controls

Image Region (If Displayed)

• Click on the available controls in the image (editable measurements are in blue text) to edit the desired areas. If a table also is displayed in the dialog, the table will automatically update after making changes in the image. 
• Select the desired options and use the associated drop-downs adjacent to the image to set the desired constraints(s). 

Table Region (If Displayed)

• Click on the data you want to edit then enter the desired data. The image above (if displayed) will automatically update. 

Additional Controls

• Measurement Units - use the drop-down to select Metric or Imperial units.