Electrical - Creepage Distance
This document is no longer available beyond version 21. Information can now be found here: Creepage Distance Rule for version 24
Rule category: Electrical
Rule classification: Binary
Summary
This rule tests the creepage distance between the targeted signals across the board surface through unplated holes, cutouts, and around the board edge.
Constraints
- Creepage distance - a rule violation is flagged when any point on the First Object is equal to or less than the distance from any point on the Second Object.
- Ignore Internal Layers - use this option to ensure the rule will only be applied to outer layers.
How Duplicate Rule Contentions are Resolved
All rules are resolved by the priority setting. The system goes through the rules from highest to lowest priority and picks the first one whose scope expressions match the objects being checked.
Rule Application
Online DRC, Batch DRC, and during autorouting.
Notes
- The Creepage Distance rule is not enabled for Online or Batch design rule checking by default. Enable Online/Batch checking in the Design Rule Checker dialog (Tools » Design Rule Check, Electrical category).
- The display of rule violations may also need to be configured, Violation Details (localized violation information) and/or Violation Overlay (highlighting of the entire objects in violation) is enabled in the PCB Editor - DRC Violation Display page of the Preferences dialog.
- The rule identifies the closest points on the targeted nets and checks the distance between them in the X, Y, and Z planes.
- If a board slot has been created by placing a pad, make sure that the Plated option is disabled in the pad properties as the software assumes that the plated barrel is conductive and will reduce the creepage distance accordingly.