Parent page: PCB Commands
The following pre-packaged resources, derived from this base command, are available:
Applied Parameters: RunRuleWizard=True
This command is used to run the Design Rule Wizard, from where you will be guided, step-by-step, through the process of creating a new design rule.
This command is accessed from the PCB Editor by choosing the Design » Rule Wizard command from the main menus.
After launching the command, the Design Rule Wizard will open. Use the pages of the Wizard to create a new design rule. Steps involve:
If the Launch main design rules dialog option is enabled on the last page of the Wizard, the PCB Rules and Constraints Editor dialog will open upon clicking the Finish button. This dialog can be used to edit the constraints for your newly-created rule.