SimView_Cmd-ZoomZoom_AD

Applied Parameters: Action = InAtCursor

Summary

This command is used to bring the waveform(s) closer to you relative to the cursor position in the active simulation analysis chart.

Access

This command is accessed from the SimData Editor by using the PgUp keyboard shortcut.

Use

Launch the command to zoom in on a particular section of a waveform. Use the command repeatedly to zoom in more.

Notes

• As this command is relative to the cursor position, it is a good idea to position the cursor in the desired location prior to launching the command then use the shortcut.
• Zooming is applied to all waveforms in all wave plots in the chart and is therefore independent of waveform/wave plot selection.

Applied Parameters: Action = OutAtCursor

Summary

This command is used to move the waveform(s) away from you relative to the cursor position in the active simulation analysis chart.

Access

This command is accessed from the SimData Editor by using the PgDn keyboard shortcut.

Use

Launch the command to zoom out from a particular section of a waveform. Use the command repeatedly to zoom out more.

Notes

• As this command is relative to the cursor position, it is a good idea to position the cursor in the desired location prior to launching the command then use the shortcut.
• Zooming is applied to all waveforms in all wave plots in the chart and is therefore independent of waveform/wave plot selection.

Applied Parameters: Action = Redraw

Summary

This command is used to refresh the screen, in effect, perform a redraw of the active simulation analysis chart to remove any undesired drawing update effects.

Access

This command can be accessed from the SimData Editor in the following ways:

• Choose the View » Refresh command from the main menus.
• Use the End keyboard shortcut.

Use

After launching the command, the screen will be refreshed and the active chart is redrawn.

Note

This command does not affect the current view setting of the Waveform Analysis window.

Applied Parameters: Action = InAtCenter

Summary

This command is used to bring the waveform(s) closer to you (zoom in) relative to the center positions of each associated wave plot in the active simulation analysis chart.

Access

• Choose the View » Zoom In command from the main menus.
• Click the  button on the SimView Standard toolbar.
• Use the Z keyboard shortcut to access a pop-up menu of zoom commands then choose Zoom In on the menu.

Use

Launch the command to zoom in at the center of each wave plot. Use the command repeatedly to zoom in more.

Note

Zooming is applied to all wave plots in the chart and is, therefore, independent of wave plot selection.

Applied Parameters: Action = OutAtCenter

Summary

This command is used to move the waveform(s) away from you (zoom out) relative to the center positions of each associated wave plot in the active simulation analysis chart.

Access

• Choose the View » Zoom Out command from the main menus.
• Click the  button on the SimView Standard toolbar.
• Use the Z keyboard shortcut to access a pop-up menu of zoom commands then choose  Zoom Out on the menu.

Use

Launch the command to zoom out at the center of each wave plot. Use the command repeatedly to zoom out more.

Note

Zooming is applied to all wave plots in the chart and is, therefore, independent of wave plot selection.