PCB_Dlg-DiffPairsRuleWizardDifferential Pair Rule Wizard_AD

The front page of the Differential Pair Rule Wizard.

Summary

The Differential Pair Rule Wizard is designed to walk you through the process of setting the required design rules. The scope used for the created rules will depend on what was selected in the PCB panel when the Rule Wizard button was clicked; if one pair was selected then the rules will target the nets in that pair, but if a differential pair class was selected then the rules will target the nets and all pairs in that class.

Access

From the Differential Pairs Editor mode of the PCB panel, click the Rule WIzard button in the bottom-right corner.

Options/Controls

Choose Rule Names

This page of the wizard is used to set names for the rules to be created. In each respective text field, enter the Prefix, Matched Lengths Rule Name, and Differential Pair Routing Rule Name.

Choose Length Constraint Properties

On this page of the wizard, you can enter the properties for the matched length rule to be applied to the selected differential pairs. Under Ruler Properties, enter the desired Hole Tolerance in the text field and enable any of the following desired rule checks:

• Check Nets Within Differential Pair
• Check Between Differential Pairs
• Check Between xSignals
• Check Between other Electrical Objects

Use the Rule Priority section of the Wizard to organize rules in order of preference, using the Increase Priority and Decrease Priority buttons. Note that these are only available when at least two rules are present.

Choose Routing Constraint Properties

This page of the Wizard allows designers to view and edit the properties for the differential pair routing rule to be applied to the selected differential pairs. Properties shown in blue can be edited by clicking on them to open a text field. Likewise, click on a property within the Ruler Properties section table to edit that property.

Use the Rule Priority section of the Wizard to organize rules in order of preference, using the Increase Priority and Decrease Priority buttons. Note that these are only available when at least two rules are present.

Rule Creation Completed

The final page of the Differential Pair Rule Wizard summarizes the differential pair rules created. If any changes are needed, use the Back button to navigate back through the wizard and make any desired changes. Otherwise, click Finish to save the created rules and exit the wizard. Upon exiting, you will be returned to the Differential Pairs Editor mode of the PCB panel.